Connect to
Use the guides below to find your adapter.
Connect To: Pressure transmitter, Chart recorder, Pressure switch or Flow computer
Where are you connecting it?
To a 3 or 5 valve manifold or ball valve?
-
For NPT pipe thread connections...
- Permanent connection use NPT Male Quick-test Fittings
- Non-permanent connections use NPT Male Quit-test Adapters or NPT Male Quick-disconnect Adapters
-
For Tube fittings...
- Use Tube Fittings
-
For Flare Fittings...
-
Through the bleeder port on the DP cell?
- Permanent connection use DP Bleed Port Quick test
- Non-permanent connections use DP Bleed Port
Connect To: Pressure calibrator
To mount the calibrator directly on the hand pump or nitrogen control device...
Use NPT Male Quick-test Pressure Calibrator Adapter
To run a hose to the calibrator if the calibrator is too large to mount directly
Use NPT Male Quick-test Adapters or NPT Male Quick-test Fittings
Connect To: Pressure gauge
To mount a test gauge directly to a hand pump or nitrogen control device...
Use NPT Female Quick-test Gauge Adapter with a Quick-test Hose
To connect to a pressure gauge at the end of a hose using thread sealant and a wrench...
Use NPT Female Quick-test Adapter with a Quick-test Hose
To connect to a pressure gauge without thread sealant or a wrench...
Use NPT Female Quick-disconnect Adapter with a Quick-test Hose
Connect To: Hand Pumps
NPT connections...
Use NPT Male Quick-test Adapter or a NPT Male Quick-test Fitting with a Quick-test Hose
BSPP connections...
Use BSPP Male Quick-test (RS) Adapter or a BSPP Male Quick-test (RS) Fitting with a Quick-test Hose
Connect To: Primary Standard
To connect a dead weight or piston gauge or pressure controller...
For NPT connections use Custom Hoses
For Tube fittings use Custom Hoses